AnandTech Storage Bench - The Destroyer

The Destroyer is an extremely long test replicating the access patterns of heavy desktop usage. A detailed breakdown can be found in this review. Like real-world usage and unlike our Iometer tests, the drives do get the occasional break that allows for some background garbage collection and flushing caches, but those idle times are limited to 25ms so that it doesn't take all week to run the test.

We quantify performance on this test by reporting the drive's average data throughput, a few data points about its latency, and the total energy used by the drive over the course of the test.

AnandTech Storage Bench - The Destroyer (Data Rate)

The BX100's performance on The Destroyer isn't dead last, but it underperforms for its capacity.

AnandTech Storage Bench - The Destroyer (Latency)

Average service time is startlingly high and is close to a hard drive's seek time.

AnandTech Storage Bench - The Destroyer (Latency)

AnandTech Storage Bench - The Destroyer (Latency)

The frequency of performance outliers is in line with the other two low performers on this test, indicating that the BX200's performance doesn't stutter any more often, but it pauses for longer periods of time when it does stutter.

AnandTech Storage Bench - The Destroyer (Power)

Higher power consumption is to be expected from a drive using TLC NAND, but the BX200 consumed more than twice the energy over the duration of The Destroyer than any of the other drives, and more than five times as much as the BX100. The BX200 didn't take vastly more time to complete The Destroyer, so it was clearly not making good use of idle time.

Performance Consistency AnandTech Storage Bench - Heavy
Comments Locked

85 Comments

View All Comments

  • zeeBomb - Sunday, November 8, 2015 - link

    Less bits the better?
  • Dahak - Tuesday, November 3, 2015 - link

    So I had primarily just skimmed the article, but for a successor to the BX100 its not.
    I wonder if there is some firmware bug that might be causing an issue.

    I have used the BX100s fine in general office settings, but i many need to pass on these and start to look for an alternative
  • mczak - Tuesday, November 3, 2015 - link

    Honestly I think the BX200 as a cheap SSD makes sense. The problem with the BX100 was that it was "too good". There was just about no difference in performance to the MX200 (faster in some benchmarks even), there was some feature differences (for instance no AES encryption, albeit this seems to have been an artificial firmware limitation as the controller supports it) but who cares about that in client ssds. But on the downside, there was just about no price difference to the MX200 neither, some shops selling some capacities of the BX100 actually for more than the same capacities for the MX200 sometimes. So the Crucial BX100 and MX200 were really pretty much the same in nearly all aspects.
    But with BX200 this changes - the MX200 now clearly is the better product, but the BX200 definitely is cheaper (or at least retail prices really need to be cheaper). Albeit the benchmarks are definitely concerning - even with tlc nand it shouldn't be THAT bad, maybe indeed the firmware is to blame.
  • hojnikb - Tuesday, November 3, 2015 - link

    Actually, TLC is pretty bad and is mostly the sole reason why this drive performs so badly. Remove the SLC cache and it would be much worse (especially on paper).
  • mczak - Tuesday, November 3, 2015 - link

    I don't quite agree. There's other tlc nand ssds in the benchmarks. Even if you exclude the 850 Evo (with its 3d nand) there's still the (toshiba tlc nand based) ocz trion 100. And this performs quite ok - sure it's not exactly leading but it doesn't trail by huge amounts in some benchmarks like the bx200 does. I'd have expected the bx200 to perform close to that rather than a league of its own as far as slow ssds go... I don't know though if that's due to differences between toshiba tlc and micron tlc or if that's due to controllers.
  • Drumsticks - Tuesday, November 3, 2015 - link

    It can't be *just* the NAND. The other TLC based drives in the charts perform much closer to "mainstream" than "absolutely terrible at everything"
  • hojnikb - Tuesday, November 3, 2015 - link

    its pretty hard to make good tlc. so yeah, tlc from micron simply sux. no other way around it.

    its no controllers fault, as it should perform just fine on its own, since its based off *46
  • DanNeely - Tuesday, November 3, 2015 - link

    Assuming the street price does settle in at a reasonable discount to MSRP (and thus is cheaper than most other budget drives), these look like a reasonable option for office work. It look ~4 minutes of sustained full writes for the 480GB model to choke. Outside of photo/video editing the only time a normal user is going to hit that long of a sustained write is for OS or very large software installs. The rest of the time, most writes will be a few seconds at most before an idle period gives the drive time to catch up and flush the ram/SLC caches; meaning they should mostly sit in the (short) burst where the drives IO is similar to what much higher end drives achieve; and most longer operations will still fit in the middle plateau which is similar in performance to most budget drives on the market.
  • beginner99 - Tuesday, November 3, 2015 - link

    Too expensive or too low performance. I think everyone can afford that $20 to step up to a MX200 or similar. And this $20 is more than worth it given the extra performance. Off topic but I would also like how older SSDs fare in these benches just as a comparison. Say I have an intel G2, will I actually gain anything noticeable from moving to a new SSD?
  • Mangosteen - Thursday, November 5, 2015 - link

    Yup! You can go to anandtechs excellent bench:

    http://anandtech.com/bench/SSD/65

    The 2013 benchmarks include a "Intel X25-M G2 160GB" (or the 80GB) which is what I'm going to assume is an Intel G2.

    You can compare 1 to 1 with any SSD for example with a 250GB 850 Evo you see big gains just about everywhere, so you will definitely gain performance but will that actually be noticeable to you i have no idea because it depends on what you will use it for. For sure it won't be AS big a gap as going from a HDD to an SSD was but you may notice some small gains. It's hilarious because in the overall listing of all the ssd's there is a "Velociraptor 10,000 rpm" HDD to compare to the SSD's which is awesome. Keep in mind also that you get a new (probably better) warranty and a larger guaranteed durability.

Log in

Don't have an account? Sign up now